Pfaff Creative 2140 - Move the Design Within the Hoop

4 Operate the
multi-color touch screen
4-31
On the screen, the most important
settings are directly
visible and selectable.
Touch to call up each
additional design that you wish to
include in the
embroidery combination.
A
version of the main menu appears to enable you to
call
up
each
additional design.
Touch to access
the machine’s memory.
Save the
embroidery combination in the machine’s
memory or on
a
creative memory card.
More options
for
adjus
the embroidery combination
are
accessed by
touching
Touch to close the window.
A design is normally
placed in the center of the hoop. The
position of any
design can
be
adjusted.
Exception: Continuous designs
from
the
machine
s
memory.
For instructions
on how
to
perform embroidery please
refer
to the Embroidery
I card section.
Move the design within the hoop
The design is placed in the
center of
the
embroidery field
(hoop). This
position
can be adjusted.
Touch kt1 to access more
options for adjusting the
embroidery combination.
Use the icon to open a screen
where
the
embroidery
design or combination can be moved
within
the
hoop,
enlarged and rotated in 5
degree
steps.
Use the cursor arrows to move the
marked design or
embroidery combination within the hoop.
The numbers at the upper
edge
of the window show you
how far (in mm) your design is moved from the center of
the
hoop.
Save your change
by
touching the
window is then
closed, If
you
press the foot control, all changes
will
be
saved but the window remains open, allowing you to
make
further changes.
Touch . the
window is closed, and
moved designs
return to
their
original position.