Pfaff Creative 2140 - Changing the Presser Foot; Electronic Knee Lift

2-10
2.
Machine
Assistant
Changing
the
presser
foot
Removing
the
presser
foot:
Set
the
needle
at
its
highest
position.
Raise
the
presser
foot
and
press
the
foot
upwards
at
the
front
and downwards
at
the
back
at
the
same
time
until
t
snaps out
of
the
presser
foot
holder (9).
When
disengaging
buttonhole
foot
5A,
the
runner
must
be
pulled
to
the
back
and
pressed
upwards.
Replacing
the
presser
foot:
Place
the
presser
foot
under
the
presser
foot
holder (9)
so
that
the
pins
of
the
foot
engage
in
the
presser
foot
holder
when
the
presser
foot
lifter (42)
is
lowered.
Check
that
the
presser
foot
has
engaged
properly
by
raising
the
presser
foot
lifter.
Electronic
knee
lift
Your
Pfaff
creative
2140
is
provided
with
an
electronic
knee
lift
for
regulating
the
presser
foot
height.
1.
Push
the
knee
lift
fully
into
the
provided
hole
(5)
on
the
machine.
Note:
the
flat
side
must
face
upwards.
2.
Adjust
the
rectangular
bar
on
the
knee
lift
until
it
is
positioned
at
a
comfortable
height
for
you.
If
you
press
the
knee
lift to
the
right,
the
presser
foot
will
raise.
Now
you
can
guide
the
fabric
with
both
hands.
3.
To
remove
the
knee
lift,
just
pull
it
out
of the
hole.
1.
2.
3.