Pfaff Creative 2140 - Position and Additional Design

6.
Embroidery
Assistant
6-25
• Now,
use the embroidery
template
to move and rehoop
the
fabric in such
a
way
that the
marking grooves
on the
left side
of the template
lie congruent
to the previously
drawn marking
line on the
right of the
fabric.
The
lower marking
slits lie congruent
with the
horizontal
line.
The bottom, left
corner of the
template then lies
automatically
on the drawn
corner point of
the fabric.
• Now
place the
embroidered template
on the fabric in
such
a
way
that the 2nd
design is
positioned to the 1
st.
• If
the needle is
positioned directly
above the
marked line
in
the center of
your test design,
the 2nd design
is then
automatically positioned
to the 1st
design.
r.
• Touch
:
to move
the design
until the needle
is
positioned
above the
center of
the design.
• Embroider the
2nd design.
It
is
automatically
positioned
next to the 1st
design.
Position
an additional
design
You can
use the function “Orbiting
the
design” to position
the
design within
the hoop. In
this way,
use a fabric marker
to
mark the boundaries
of the
design on your fabric
and
therefore the starting
point for
another design
(as not every
design
is
as
wide
as the hoop).
Touch
L.
The design will
then
be
orbited
in the form
of
a rectangle.
The hoop moves
gradually forwards
while
the
icon
is touched.
• If
you remove your
finger from the icon,
the machine
will
stop at this
position.
• If
you hold down
the icon, the
machine will
automatically
stop in the four
corners of the
orbited rectangle.
• Mark
the corner points
of the orbited
rectangle.
• Use
a
fabric
marker, draw
a vertical line which
crosses
the lower
horizontal line. The
point of intersection
represents the
bottom, left
corner point.
• Use the embroidery
template, rehoop
the fabric in
such
a
way
that the marking
grooves
on the left side of the
template
are again congruent
to the marking
line drawn
on the
fabric. The lower
marking slits lie
congruent to the
horizontal
line.
The
bottom, left
corner of the
template then lies
automatically on
the corner point
which has
been drawn
on the fabric. The
machine always
drives
to the center of
the design before
commencing
a design and
after it has
embroidered
a design.
• Now proceed
as described on
page 6-24.
• This way
you can combine
as many
designs as
you
want, until
the border has
reached
your required size.
ooeO
I
hi