Pfaff Creative 2140 User Manual

Eyelet
plate
Using
an
eyelet
plate
you
can
create
traditional
eyelet
embroidery.
The
eyelet
plate
is
available
in
4
mm,
6
mm
and
8
mm sizes.
•
Remove
the presser
foot and
place
the eyelet
plate onto
the needle
plate.
Make
sure
that the
pin at
the back
of
the plate
fits
into
the
middle
cutout
of the
needle
plate.
Push the
plate
down
at the
front.
•
Tightly
hoop
your
embroidery
fabric.
Use
a stabilizer
if
necessary.
• With
sharp
scissors
cut one
or
two
of the
fabric
threads
at the
center
of the
eyelet
area
and
push
the
fabric
over
the
pin of
the eyelet
plate.
The
fabric
must
fit snugly
around
the
pin.
•
Place
the presser
foot lifter
in
the
darning
position.
• Pull
up the
bobbin
thread
and
hold
it for the
first
few
stitches.
• Stitch
around
the
cut
with
the desired
program
(e.g.
program
No.
6. 86,
87,
88).
While
doing
so,
turn
the
hoop
with
the
fabric
slowly
and
evenly.
The stitches
should
be
very
close
to
each
other.
Secure
with
a
few
straight
stitches.
Stitch
No:
optional
(utility
or decorative
stitches)
Stitch
length:
according
to
the stitch
Stitch
width:
9
mm
Ruffler
With
the ruffler
you
can make
closely
or
widely
spaced
pleats
automatically
while
sewing.
This
is very
useful
for
ruffles,
frills,
home
textiles.
etc.
The ruffler
can
be used
in three
different
ways:
1.
Folding
pleats
in fabric.
2.
Folding
and
securing
pleats
in
fabric
in one
operation.
3.
Folding
and
securing
pleats
in
fabric,
while
attaching
lace
in one
operation.
When
you
buy the
ruffler
from
your
PFAFF
dealer,
full
operating
instructions
are included.
Stitch
No:
1
Stitch
length:
3
mm
--
N

Pfaff Creative 2140 Specifications

General

Brand	Pfaff
Model	Creative 2140
Category	Sewing Machine
Language	English