Pfaff Creative 2140 - Embroidery Combinations;Combine Designs in the Hoop

6 Embroidery
Assistant
6-29
Embroidery
combinations
Our range
of creative cards includes
designs,
which are
characterized
by the fact that
they comprise
at least
2-part
designs
and can be
combined with each
other by means
of
a
connecting
point.
The last
stitch from part
design 1 represents
the
mutual
connecting
point of part
design 1 and
part design
2.
The connecting
point is
a
long stitch at the
end
of
the
1st
part design
and the beginning
of the
2nd part design.
It is
positioned
on the outside
edge of
the design
combination.
These
designs
have
been especially
created for the
“Creative
Fantasy
Big’ hoop, and can
now be embroidered
using
the
embroidery
hoop of your
machine.
We
distinguish between
two groups:
• Design
combinations,
which consist
of 2-part
designs.
• Endless
border
combinations, which
always end with
a
connecting
stitch
and can
be
combined
as
often as
one
desires.
Combine
designs
in the hoop
Preparing
the fabric
Use a
fabric
marker, to draw a
marking line on
your fabric in
the
direction
in which the border
is to
be
embroidered.
This marking
line is an aid for hooping
the
fabric.
When
hooping, ensure
that
the marking
line runs across
through
the center
of the embroidery
field.
For this purpose,
refer to the
marking slit in the
center
of
the
hoop.
• Select the
design
section
with number
“1” from the
creative
card. We have
selected our
designs from
the
card 52
I embroidery
combinations.
• Position
it in the hoop. In
doing so, the
design must
not be
mirrored lengthwise as
it ends
with
a
connecting
point.
• Select the
design section
with
number
“2”.
Likewise,
this
part design must
not
be
rotated lengthwise.
• Position
this part directly
against
the
1st part design.
•
Touch - to enlarge the
area
where
the
two
design
parts
meet and fit together
the
two
halves
of
the design.
• Embroider
the
1st
part
design.
• The
machine stops after it has
sewn
the connecting
point.
Tip: Do not
pull
out
the thread
of the
connecting
stitch.
• The 2nd
part
design
is now shown as
marked, the
needle
is in the position
of the
connecting stitch of the
2nd part
design.
• Now
you can check that the
needle
enters the
connecting
stitch of
the 1st part design.
• If
the connecting stitch
is correct, the
design will be
connected exactly to the
1st part
design.
• If the
needle
does
not enter the
connecting stitch of the
1st
part
design.
touch and
move the design
until the
needle enters
the connecting
point.
• Embroider
the 2nd
part design.