Pfaff Creative 2140 - Hoop Embroidery; Desengaging the Top Feed;Dual Feed; Removing the Knee Lifter; Attaching the Embroidery Foot

2-14
2.
Machine
Assistant
Hoop
embroidery
For
hoop
embroidery,
set
up
your
Pfaff
creative
2140
properly
and
attach
the
embroidery
unit
as
described
below.
It
is
not
possible
to
select
a
creative
Card
if
the
embroidery
unit
is
not
attached.
Before
hoop
embroidering
you
must
lower
the
feed
dog,
disengage
the
dual
feed
(IDT
System),
remove
the
knee
lift
and
fit
the
embroidery
foot
(see
below).
Lowering
the
feed
dog
The
feed
dog
must
be
lowered
for
hoop
embroidery.
To
lower
the
feed
dog
move
the
slide
(4)
to
the
left.
Note:
Raise
the
presser
foot
before
lowering
the
feed
dog
The
thread
tension
is
automatically
set
and
can
be
adjusted
for
speciality
techniques.
Disengaging
the
top
feed/dual
feed
The
top
feed
must
be
disengaged
for
embroidery
work.
Procedure:
Hold
the
dual
feed
firmly
at
the
ribbing
with
two
fingers.
Press
the
top
feed
(red)
fully
downwards,
then
pull
it away
from
you
and
release
it
slowly
upward
until
it
engages
in
normal
position.
Removing
the
knee
lifter
The
knee
lifter
is
not
needed
for
embroidery
work
and
must
be
removed.
To
remove
the
knee
lifter,
just
pull
it
out
of
the
hole.
Attaching
the
embroidery
foot
1.
Remove
the
standard
presser
foot.
Carefully
loosen
the
screw
(S)
until
the
cross-hole
(T)
is
accessible.
2.
Squeeze
the
embroidery
foot
gently
together
and
guide
the
pin
of
the
foot
into
the
cross
hole
of
the
presser
foot
holder
as
far
as
it
will
go.
3.
Tighten
the
screw
(5).
To
remove
the
embroidery
foot
loosen
the
screw
(S),
squeeze
the
embroidery
foot
together
and
pull
it
out
to
the
right.
Tighten
the
screw
(S).
-Th
/
i’i’
nnnninnnnnnrn
1.
2.
3.