Pfaff Creative 2140 - Embroidery;Card - Embroidery Alphabets

i’%
Rotating
Use this
icon to
you
can rotate
your design
in steps
of
50
in the direction
of the
arrow.
Thread
tension
)j(
You can
adjust
the thread
tension
(tighter
or
slacker) with
the
+1-
icons.
Ei
Repositioning
If
you
rotate
a
design and
it then protrudes
beyond
the hoop,
a
red line
appears in place
of
the
hoop.
This
line alerts
you
to
the fact
that the design
cannot be
embroidered
in this
position.
The design is
automatically
placed into
the
embroidering
field
with this function.
Undo
This function
cancels
the
command
described
above and
places the design
back
outside the
hoop. allowing
you
to continue turning
it.
If no red
line is visible,
a
design is
within the hoop
and
can
be
embroidered.
Positioning
With this function,
you
open
a
window
for positioning
your
design within
the hoop.
Dialogue
window:
Using the arrows
you
can
displace
the design
within the hoop.
The
numbers
at the
upper
edge
of
the window
show you
how far
(in
mm) your
design is displaced
from
the center of
the hoop.
Enlarged
representation
With
this function,
you obtain an
enlarged representation
of the design
on the
screen, as upon
design
selection.
By
touching
“esc”
you switch
back to
the previous
screen,
without saving
the changes.
Embroidery
I
card
— Embroidery
alphabets
If
you
select
“Alphabets”
in Embroidery/card.
the
processing
screen
for
the embroidery
combination
is opened.
Therefore
the
available
icons
are displayed
in the same colors
as
for the
embroidery
combination.
The
following icons,
which are
displayed in the
same
colors
as the
embroidery
combination.
only appear
when
“Alphabets’
is selected.
Activity
arrows
Using
these arrows
you can scroll
through
the screen.
Zoom
up
You
can
enlarge
the representation
in several
steps.
The zone
around
the
marked
letter
or letter combination
is
the
area
that is enlarged.
Zoom
down
You can
reduce
the representation
in
several
steps. The
zone
around
the
marked
letter or
letter combination
is
the
area
that
is
reduced.
Marking
In
order
to process a
design,
it must
be
marked.
You can
mark
a letter
or letter
combination.
A
red dash appears
for this purpose:
you
can move
it across the
letters
to be
marked with
the cursor icons.
The
marked
letter or letter
combination
is
surrounded
by a
colored frame.
If you
move over
a
previously
marked
letter
or letter
combination,
the marking
is
cancelled
again. The
representation
turns
black.
Deleting
You can
delete
a
previously
marked
letter
or letter combination.
More
functions
for
embroidery
combination
By
touching this
icon
you
can call
up
further
functions
for processing
or
modifying
the
design.
Touch the icon
a
further time
to
close
the
window.