5.Assemble the oil pump.
a. Assemble the oil pump by reversing above procedure.
b. Be sure oil pump screw is tightened.
6.Releasing air in the oil pump.
(a)Fill up specific amount of oil to oil tank.
(b)Place dry cloth under the oil pump.
©Remove oil pipe.
(d)Use injector to fill up the oil in the oil pipe and oil pump body . Be sure the oil
pipe and oil pump are full of oil
before assembling.
(e)After assembling check if there
is still air trapped in the oil pipe.
After assembling, check the following:
a. the adjustment of control cables
b. Is there air in oil pipe.
c. oil leakage at any location.
a. If there is air in the oil pipe, it will cause engine lubrication trouble
b. Releasing air operation means the release of air trapped in the air pipe
and oil pump. Please firstly release air from the oil pipe
O-ring of oil pump should be lubricated by grease or oil, then place on crankcase.
The contact surface of oil pump and crankcase should be assembled firmly.
The gears of oil pump should be lubricated by grease.
To Next Page
Loading...
