PGO G-MAX200 - Assemble the Crankcase

3.measure the swingness of crank shaft neck.
Limit of use
A B
Change it when
Above 0.1mm
Change it when
Above 0.1mm
4.check the slackness of crankshaft bearing,
if it is slack, change a new one.
F. Assemble the crankcase.
1.To assemble the crankcase, please reverse the procedures of disaseembling.
2.The locking torque value for bolts and nuts are all described in the previous chapters
Please refer.
60mm
A B