PGO G-MAX200 - Check the Final Transmission Mechanism; Assemble the Final Transmission Mechanism

C. Check the final transmission mechanism
1.Check the wearing condition of the driving shaft and
gears.
2.Check the wearing condition of the idle gear shaft and
idle gears.
3.Check the wearing condition of the final reduction gear.
4.Check the wearing condition of the oil seal and bearing.
D. Assemble the final transmission mechanism:please follow the opposite procedures
Of disassembling. After locking the drain bolt, refill 90c.c of gear oil, SAE 85W/140.
Locking torque: M6: 1.0~1.2 kg-m
M10: 3.5~4.0 kg-m
Drain bolt: M8: 1.8 kg-m