Start up
Powering up the Qx
When the ‘Power Button’ on the Qx is first pressed, the unit fans will cycle for 20-30 seconds at high speed
as the system boots, then settle to their normal operating speed.
Menu selection
The following menu screen will be displayed after power up:
To activate the ‘Instrument Launch Menu’, click the PHABRIX symbol in the left hand corner of the Instrument
taskbar.
To hide the ‘Instrument Bar’, left-click within its blank area. Bringing the cursor to the bottom of screen re-
enables the ‘Instrument Bar’. A ‘Preset Bar’ can be created below the ‘Instrument Bar’.
Instrument Launch Menu
The unit has three possible boot modes: IP, SDI, and SDI Stress. On start up, you will see one of the following
menus, depending on the boot mode, and licenses applied to the unit:
PHABRIX Qx User Manual Page 7
To Next Page
Loading...