Generation
Generator - Status
[Qx 12G / PHQXO-GEN (Qx IP)]
The ‘Generator - Status’ window confirms the generated Video Standard and Test Pattern details. The
window shows the generator pattern selected, or PRBS signal selected (available in SDI Stress Toolset
Mode), and confirms the BNC output (SDIModes only) or SFP output presence, and Sub Image/Full Image
mapping information. Audio Presence & Sub Image information is also displayed, along with Video
Reference, Output offset adjustment, and Jitter insertion (SDI Stress Toolset Mode) details. This window
provides status information only; there are no user settings to configure.
When pathological overlay is generated in ‘Generator – Configuration’, the Qx detects this for all SDI
outputs, and ‘Pathological PLL/s’ and ‘Pathological Eq/s’ will display the number of pathological events that
have been generated per second. As one pathological event is created per line this also indicates the
number of lines per second on which pathological conditions occur on the interface. The detection of a
pathological condition is available as a GPI output of the Qx, for use in triggering an external analyzer device.
Note: Pathological Rate/s counters are not displayed in PRBS Mode.
Page 20 PHABRIX Qx User Manual
To Next Page
Loading...