Phabrix Qx IP Series - SFP IP Network [IP Mode]

System
SFP IP Network [IP Mode]
[IP Mode]
The ‘SFP IP Network’ window provides an overview of the status of the Qx SFP interfaces used for 2022-6
IP packet transmission and reception. IP receive (A) and transmit (B) SFP presence, carrier signal presence,
interface status, SFP MAC and IP addresses, and packet information are displayed here. Error status
information is displayed at the bottom of the window.
Right-clicking in the window reveals a submenu, from where the static IP address, and network/subnet mask
of each SFP can be set, by keyboard or on-screen Keypad.
Static IP address of SFP:
l SFP...IP addr and mask > [set IP address of SFP as required]
Mask selection is via a drop-down menu. Classless Inter-Domain Routing (CIDR) notation is used; with a
default value of /24 (i.e. 255.255.255.0):
l SFP...IP addr and mask > [set mask in drop-down, 30 to 8]
Default Gateway:
l SFP...Gateway IP Addr > [set Gateway IP address as required]
IP settings are saved by selecting:
l Apply SFP...Static IP Parameters
PHABRIX Qx User Manual Page 21