The output audio signal source is the Qx audio generator (See ‘Audio’ tab of ‘Generator –
Configuration’ instrument.)
l Transmit - Analyzer: I/O is set to AES Output
The output audio signal comes from Image/Sub-image 1 of the Qx analyzer input (SDIor IP
2022-6)
l Transmit - Passthrough: I/O is set to AES Output
The output audio signal is routed from the chosen AES input ‘Passthrough Source’
Configure the AES I/O's via the instrument submenu:
l AES 1/2/3/4 Mode > [Off, Receive, Transmit - Analyzer, Transmit - Generator, Transmit - Passthrough]
l AES 1/2/3/4 Mode > Transmit - Analyzer/Generator > AES 1/2/3/4 Transmit Pair > [Group 1: Pair 1, Group
1: Pair 2, Group 2: Pair 1, Group 2: Pair 2, Group 3: Pair 1, Group 3: Pair 2, Group 4: Pair 1, Group 4: Pair 2,
Group 5: Pair 1, Group 5: Pair 2, Group 6: Pair 1, Group 6: Pair 2, Group 7: Pair 1, Group 7: Pair 2, Group
8: Pair 1, Group 8: Pair 2]
l Passthrough Source > [AES 1, AES 2, AES 3, AES 4]
Analysis
Analyzer - Video Standard
The ‘Analyzer - Video Standard’ window displays the payloads of the video standard being analyzed. It
lists the payloads on SDI (SDI Modes) / 2022-6 SFP (IP Mode) input signals. The lower pane provides a
summary of the standard and of any analyzer overrides set.
The Payloads are identified primarily by ST-352 packets - if these are missing the signal stats will be
analyzed and a best guess payload identifier will be listed.
Unstable payloads, or those with damaged or missing ST 352 packets are indicated within the ‘Analyzer -
Video Standard’ window. Payload identifier errors are shown in red, warnings are indicated in yellow.
Ignore Payload Identifier Packets (ST 352)
ST-352 packets can be ignored such that a best guess payload identifier is used.
Page 28 PHABRIX Qx User Manual
To Next Page
Loading...