The destination MAC address should be set as required, to ‘Automatic’ for multicast, or ‘SFP A’ for unicast
transmission to the same Qx unit. For unicast transmission to another device, set to ‘Manual’, and then enter
below, the MAC address of the receive device (in the case of a direct connection) or the first switching
device in the path of the transmitting Qx (in the case of an indirect connection to the receive device).
l Dst MAC Addr > [Automatic, Manual, SFP A]
UDP parameters:
l Src UDP Port > [set UDP port number as required]
l Dst UDP Port > [set UDP port number as required]
A Synchronization source identifier (SSRC) can be set for Real-time Transport Protocol (RTP) stream
subscription if required:
l SSRC > [set ID if required]
Once required network settings have been entered, switch ‘On’ ‘Transmit’ to commence transmission.
Note: Ensure also, that you are generating a test signal for transmission in ‘Generator - Video Standard’.
System
SFP (A, B) - Info
The ‘SFP - Info’ windows gives at-a-glance physical status information on each Qx SFP module, including
Identifier, Connector, line code (Encoding), Vendor details and approval status for use with the Qx. More
detailed status information for the SFP, such as temperature and voltage are also displayed.
Temperature and Power display units can be adjusted via the right-click submenu:
l Temperature Units > [°C, °F]
l Optical Power Units > [mW, dBm]
PHABRIX Qx User Manual Page 23
To Next Page
Loading...