System
Event Logging
Logging is provided on the Qx, and logs can be viewed in ‘Event Logging’. The Qx allocates 500 lines for
logging detail before overwriting this data. It will also recall the log data last captured if the unit is started
from cold. The setting for logging data will need to be re-entered from a cold start using the right click
selection. Logs can also be accessed and saved via the REST API.
SDI Modes
By right clicking the mouse on this instrument the following drop-down menus are presented:
l Record Jitter Timing Logs > [Enabled, Disabled]
l Record Jitter Alignment Logs > [Enabled, Disabled]
l Record SDI Input Standard Logs > [Enabled, Disabled]
l Record SDI Input Rate Logs > [Enabled, Disabled]
l Record REST API Request Logs > [Enabled, Disabled]
l Record Reference Locking Logs > [Enabled, Disabled]
l Record SFP Logs > [Enabled, Disabled]
l Record Audio Input Presence Logs > [Enabled, Disabled]
l Clear logs
IP Mode
By right clicking the mouse on this instrument the following drop-down menus are presented:
l Record IP Tx Logs > [Enabled, Disabled]
l Record IP Rx Logs > [Enabled, Disabled]
l Record IP Interfaces Logs > [Enabled, Disabled]
l Record REST API Request Logs > [Enabled, Disabled]
l Record Reference Locking Logs > [Enabled, Disabled]
l Record SFP Logs > [Enabled, Disabled]
l Record Audio Input Presence Logs > [Enabled, Disabled]
l Clear logs
PHABRIX Qx User Manual Page 55
To Next Page
Loading...