Phabrix Qx IP Series - Analyzer - Vectorscope

l Brightness > [slider 1..31]
l Gamma > [slider 1..255]
l Persistence [slider 1..255]
l Monochrome Mode [Enabled, Disabled]
l S-Log3 Mode [S-Log3, SR Live]
Analysis
Analyzer - Vectorscope
Vectorscope setup is accessed by right clicking within the vectorscope area:
l Targets > [Off, 75%, 100%]
l User Markers > [Enabled, Disabled]
l User Markers > Enabled > Marker Selected > [Marker 1, Marker 2] > Marker Angle > [slider
0.00...359.99]
l User Markers > Enabled > Marker Selected > [Marker 1, Marker 2] > Marker Gain > [slider
0.00...100.00]
l I/Q Axes > [Off, I Only, Q Only, Both]
l Filter > [Flat, Low Pass, Raw]
l Centre > [Origin, Red, Green, Blue, Magenta, Cyan, Yellow, Marker 1, Marker 2]
l Single Line Mode > [Enabled, Disabled]
l Single Line Mode > Enabled > Line Number > [1 to Total no. of Lines for current standard]
l Zoom > [slider 0.50...4.00]
l Brightness > [slider 1..31]
l Gamma > [slider 1..255]
l Persistence [slider 1..255]
Page 38 PHABRIX Qx User Manual