Note: PRBS signal generation is available in the 'Generator - Video Standard' instrument submenu, as part of
'Advanced Generation Tools', in SDI Stress Toolset Mode [PHQXO-SDI-STRESS].
Note: Upon power up of the Qx unit, immediate use of PRBS generation with 'PRBS - Analysis' will not work,
as the 'PRBS - Analysis' tool cannot determine the received data rate. The initial generation of an SDIsignal
must be made to set up the clock rates. Once this is done, 'PRBS Mode' can then be enabled in 'Advanced
Generation Tools', and 'PRBS - Analysis' will work after that.
PHABRIX Qx User Manual Page 43
To Next Page
Loading...