PhaseOne P 65+ - Mounting P 65 + Back

55
10.1 Mounting P 65
+
back on the Phase One 645 AF &
Mamiya 645AFD Series
The P+ back is fully integrated with the camera body and acts as a part
of the whole camera system.
When no cassette is attached to the body the mirror is up and the
shutter is open.
When attaching a powered P 65+ back to the camera body the shutter
will close and the mirror comes down.
It is important to ensure that the bottom part of the P+ back camera
back is pressed correctly into the bottom locking mechanism before
the upper locking mechanism is pressed together. - Failure to do
this can cause an error with the camera body. The error is a state of
continuously opening and closing the shutter. If this occurs, remove the
P+ back immediately.
Please be aware that the shutter should be in the correct starting
position (shutter open), if this is not the case, attach and remove the
P+ back again to make sure that the camera body gets in the correct
starting position. (The same procedure is recommended by Mamiya for
all lm cassettes)