PhaseOne P 65+ - Hasselblad 501 CM and 503 CW Without Winder

71
12.6 Hasselblad 501 CM and 503 CW without winder
The Phase One P 65+ back also supports mechanical Hasselblad
cameras such as the 501 CM and 503 CW. These cameras are operated
in single shot mode via the shutter release button or a standard cable
release.
Please note that the Phase One P 65+ back should not be mounted
while the camera is set to mirror up.
Also make sure that the lens is not jammed or locked open on the “B”
setting when connecting the ash sync cable to the Phase One P 65+
back.
When using mirror-up function, shutter latency should be set to Zero
latency. In all other cases you should use Normal Latency.
To ensure capture reliability, it is recommended that you look at the
green LED on the back of the camera back while you slowly press the
mechanical trigger on the camera body.
You can safely press the button all the way in the moment the LED
ashes.
When using”Mirror Up” it is necessary changing shutter latency to
“Zero Latency”.