PhaseOne P 65+ - Hasselblad 503 CW with Winder CW; Hasselblad 903 CW and 905 CW

72
12.7 Hasselblad 503 CW with Winder CW
Please note that the Phase One P 65+ back should not be mounted
while the camera is set to mirror up.
Also make sure that the lens is not jammed or locked open on the “B”
setting when connecting the ash sync cable to the Phase One P 65+
back.
If you are using a 503 CW with winder you could set the Shutter latency
to”Normal Latency”.
When using”Mirror Up” it is necessary changing shutter latency to
“Zero Latency”.
12.8 Hasselblad 903CW and 905CW
These Hasselblad models have no options of communicating to a
digital back; hence you must at all time keep the latency settings at
Zero Latency.
The winder allows optional syncro-cable from the multi connector of
the back, this will make allow the back to control winding of the shutter,
this have no effect on the latency setting.