77
13.1 Mounting P 65+ back to the CONTAX 645
P 65+ back for Contax is fully integrated with the camera and acts as a
true part of the whole camera system.
When attaching P 65+ back to the camera it is important to ensure that
the bottom part of the back is pressed well into the locking mechanism
before the upper locking mechanism is pressed together.
To avoid that P 65+ is released by mistake from the camera house, the
lock button on the side of the P+ back can be used to lock the C645
locking mechanism.
Operating the camera from the host computer
The supplied release cable must be connected between the multiple-
pin connector on the P+ back and the mini-jack connector placed at
the bottom of the handgrip on the CONTAX camera house.
Bulb capture is not supported on Contax.
To Next Page
Loading...
