70
12.5 Hasselblad 553 ELX
When using the P 65+ back on some Hasselblad motorized bodies (i.e.
Hasselblad ELX or Hasselblad ELM series), a motor cable is supplied to
enable capture from the computer.
The cable is connected between the multi-connector on the P 65+ back
and the DIN connector on the Hasselblad.
Avoid using A or AS mode.
Please also note that the Phase One P+ back should not be mounted
while the camera is set to mirror up (S or RS modes). Make sure that the
lens is not jammed or locked open on the “B” setting when connecting
the ash sync cable to the Phase One P+ back.
While using the Hasselblad 553 ELX you should set the Shutter latency
to ”Normal latency” - do only change to Zero Latency setting when
using mirror up function.
It is even possible to use “Normal latency” mode on this camera when
using a motor cable and and doing the exposure by using the capture
button inside the Capture One Application.
To Next Page
Loading...
