PhaseOne P 65+ - 15 View Camera and Technical Photography

86
15.0 View camera and technical photography
The Phase One P 65+ back can be used with most wide angle cameras,
technical view cameras or large format cameras via camera interface
adaptors. The P 65+ back supports most mechanical shutters and some
electronic shutters from Horseman, Schneider and other vendors.
To enable noise free exposures without the use of active cooling of the
CCD, Phase One has developed the “Phase One Sleeping Architecture”.
The sleeping architecture ensures minimum heat build up inside the
back, by putting all the unused circuits to sleep, and only powering the
circuits that are actually needed at any given time.
Using Zero latency removes the need to wake up the back prior to the
actual exposure, hence you just need to connect the standard ash sync
cable to the digital back and the lens, and shoot. The Zero Latency will
however increase you power consumption signicantly, and this power
consumption should be on your mind if creating outdoor pgotography,
not having other power source than battery.