Philips 55PFL5907 - 4 Use Your TV; Switching on Your TV and Putting It in Standby Mode; Adjusting Volume; Switching Channels

English
15
4 Use your TV
Switching on your TV and putting it in
Standby mode
To Turn Power On or to Turn Standby On
• Press
.
onthesidepanelortheremotecontrol.
Note
• Energyconsumptioncontributestoairandwaterpollution.WhentheACpower
cordispluggedin,yourTVconsumesenergy.YourTVhasverylowStandbypower
consumption.
Adjusting volume
To increase or decrease volume
• Press+(up)/−(down) (VOLUME) onthesidepanelorpress+/−
(VOLUME)ontheremotecontrol.
To mute or unmute sound
• Press (MUTE)ontheremotecontroltomutethesound.
• Press
(MUTE)againor+/− (VOLUME)torecovertheoriginal
sound.
Switching channels
To select Channels by using CH +/−
• PressCH +(up)/−(down) onthesidepanelortheremotecontrol.
To select Channels by using the NUMBER buttons
DigitalTVoperation
• ForDigitalchannels,pressanumberfollowedbyadot“•”andthe
correspondingsubchannelnumber.
– WhenselectingDigitalchannel11.1
 Besuretopress•beforeenteringthesubchannelnumber.

Analog/CableTVoperation
– WhenselectingcableorAnalogchannel11

Press (PREV.CH)toreturntothepreviouslyviewedchannel.
Note
• Toselectthenon-memorizedchannels,usethe NUMBER buttons.
• Channel not available or No SignalwillappearontheTVscreenafterthesubchannel
broadcastisover.
• Audio onlymessagewillappearontheTVscreen,whenyoureceiveonlysoundsignal.