Philips BDL3245E/00 - Remote Control Functions

17
3.3 Remote Control
1. [POWER] Button
Press to switch on the display from standby mode.
Press again to turn it off and back into standby
mode.
2. [SMART] Button
Press to activate Smart Menu. Press [▲] or [▼]
button to select menu options. Press [SET] button
to confirm and exit selection.
• Standard: used for normal images (factory
setting)
• Highbright: used for moving image such as video
• sRGB: used for text based images
3. [PIP] (Picture In Picture) Button
[ON/OFF]: Turn PIP mode ON/OFF.
[INPUT]: Select the input signal for the sub
picture.
[CHANGE]: Toggle between the main picture and
sub picture.
4. [CONTRAST] Button:
Press to activate Contrast Menu. Press the [+] or
[-] button to adjust the value. Press [MENU]
button to confirm and exit.
5. [DISPLAY] Button
Press to turn on/off the information OSD display on
the upper right corner of the screen.
6. [-] Button
• Press to move the selection left in OSD menu.
• Press to decrease the value in OSD menu.
• Press to move the sub picture left in PIP mode.
7. [SET] Button
Press to activate the setting inside the OSD menu.
8. [AUTO ADJUST] Button
Press to run the Auto Adjust function.
Note: this button is functional for VGA input only.
9. [MUTE] Button
Press to turn the mute function on/off.
10. [VIDEO SOURCE] Button
Press to toggle Video Source Menu. Press [▲] or
[▼] button to select one of the video sources
among HDMI, DVI-D, VGA, Component, S-Video,
or Video. Press [SET] button to confirm and exit.
11. [AUDIO SOURCE] Button
Press to toggle Audio Source Menu. Press [▲] or
[▼] button to select one of the audio sources
among HDMI, AUDIO1, AUDIO2, or AUDIO3.
Press [SET] button to confirm and exit.
12. Picture Format button
Press to switch screen aspect ratio.
 For PC signal: Full, Normal, Custom and Real.
 For Video signal: Full, Normal, Dynamic, Custom,
Real, and 21:9.