External Assemblies
4-8 Removal and Replacement
3. Remove the printer assembly.
Pull the printer straight up out of the printer bucket. See Figure 4-2 on
page 4-8.
4. Disconnect the ribbon cable.
Unlatch the connector latches and unplug the ribbon cable as shown in
See Figure 4-2 on page 4-8.
TIP: If you are installing a replacement printer, remove the 4 screws
now. If you are moving the printer to a new Top Case Assembly, save
work by leaving the screws in place.
Figure 4-2 Removing the Printer
Ribbon Cable
Connector
Printer ribbon cable
To Next Page
Loading...
