Internal Assemblies - Top Case
4-64 Removal and Replacement
Speaker
These instructions describe how to remove and replace the speaker assembly.
Preparation
1. Save the configuration.
If possible, save the customer’s configuration onto a Data Card (or print
the configuration) so the configuration can be restored after the repair is
complete.
2. Open the case safely.
See "Opening the Case" on page 4-24.
Removal
1. Disconnect the Speaker
Disconnect the speaker from the Control PCA. Refer to Figure 4-20 on
page 4-37 to identify the speaker connector.
2. Remove the speaker.
a. Remove the two screws and clamps from the speaker. See
Figure 4-33.
b. Peel up the tape holding the wires in place. Lift the speaker and its
wires out of the case.
Figure 4-33 Removing the Speaker
Speaker
Clamp
(2 Total)
To Next Page
Loading...
