M4735A Service Manual 2-11
Configuration and Diagnostic Modes
2
Configuration and Diagnostic Modes
The instructions below describe how to enter Configuration Mode and
Diagnostic Mode.
Configuration Mode
These instructions describe briefly how to use Configuration Mode. See the
Instructions for Use for details on configuration settings and what effect they
have.
CAUTION Inserting or removing the Data Card while the unit is on can corrupt the Data
Card and prevent the unit from powering on again. If this occurs, see Chapter
3, Troubleshooting.
1. Power off.
Make sure the unit’s power is off.
2. Insert a Data Card (if applicable).
If you intend to save the configuration to a Data Card (or load the
configuration from a Data Card), insert the Data Card now. To avoid
possible confusion, designate one Data Card as the “Configuration Card”
and label it clearly. Keep this card physically separate from cards used by
the clinical staff for data storage.
3. Enter Configuration Mode.
Press softkeys 4 and 5 at the same time, and hold them down while
turning the power on. See Figure 2-1 for softkey numbering.
4. Select and manage Configuration choices.
z To select a configuration, press the and softkeys to move up
or down the list until the desired Settings item is highlighted. Then
press the softkey to access those settings.
z To print out a strip with all the current configuration choices, select
Print All Settings and press .
z To store the configuration settings on a Data Card, select Save Set-
tings to Data Card and press . When prompted with Save Set-
tings to Data Card? press .
z To load configuration settings from a Data Card, select Load Settings
from Data Card and press . When prompted with Load Settings
from Data Card? press .
ENTER
ENTER
ENTER
SAVE
ENTER
LOAD
To Next Page
Loading...
