FL MGUARD GT/GT
105656_en_05 PHOENIX CONTACT 167
Figure 8-3 Example of FL MGUARD GT/GT status indicators
Example:
In Figure 8-3, the LED indicators have the following meaning:
A: The MODE switch has been set to display the duplex mode (FD); the mode LEDs now
indicate that the LAN port is in half duplex mode and the WAN port is in full duplex mode.
B: The switch has been set to display the Activity (ACT); the mode LEDs now indicate that
incoming data packets are detected on both ports.
Another LED is located on the front of the device for the LAN and WAN port. The function of the second LED
(MODE) for each port can be set using the MODE switch (see also example below). There are three options
(during the boot process the mode and port LEDs are permanently on):
ACT
(Activity)
Green On Receiving telegrams
Off Not receiving telegrams
SPD
(Speed)
Green/
orange
On (orange) 1000 Mbps
On (green) 100 Mbps (for RJ45 ports only)
Off 10 Mbps if Link LED is active (for RJ45 ports only)
FD
(Duplex)
Green On Full duplex
Off Half duplex
ACT/SPD/FD Yellow Flashing The device is in Smart mode (see “Restart, recovery procedure, and flashing the
firmware” on page 186)
INF
(Duplex)
Green On VPN tunnel established
Flashing VPN tunnel initialized
Off No VPN tunnel
Table 8-2 LEDs on the FL MGUARD GT/GT [...]
LED State Meaning
00.A0.45.06.04.02
MAC
Address
US2
FAIL
X5
US1 GND
X7
R1 R2
FL MGUARD GT/GT VPN
Ord. No. 2700198
US1
X9
V.24
SPD
FD
ACT
MODE
WAN
MODE
INF
LNK
X3
LAN
MODE
INF
LNK
X4
X1
X2
X8
MEM
X6
MC1 GND
A
B
To Next Page
Loading...
