FL MGUARD GT/GT
105656_en_05 PHOENIX CONTACT 187
Exiting Smart mode and activating the selection
• To exit, press and hold down the Mode button for at least five seconds. The previously
selected function is executed.
Possible functions in Smart mode
The device supports the selection of the following functions in Smart mode (see also exam-
ple below):
8.8.2 Performing a restart
Objective The device is restarted with the configured settings.
Action See "Function selection by means of mode button (Smart mode)" for how to start the func-
tion type.
(Alternatively, disconnect the power supply and then connect it again.)
8.8.3 Performing a recovery procedure
Objective (to 8.3.x) To mGuard firmware version 8.3.x
The network configuration (but not the rest of the configuration) is to be reset to the de-
livery state, as it is no longer possible to access the device.
Use the recovery procedure if you do not know the IP address under which the device can
be accessed.
The following network setting is restored:
The device is reset to router mode with the fixed IP address.
– The CIFS integrity monitoring function is also disabled because this only works in
Stealth mode when the management IP is active.
– In addition, MAU configuration is activated for the Ethernet connections. HTTPS ac-
cess is enabled via the local Ethernet connection (LAN).
– The settings configured for VPN connections and the firewall are retained, including
passwords.
Possible reasons for performing the recovery procedure:
– The device is in Router or PPPoE mode.
– The configured IP address of the device differs from the default setting.
Table 8-6 Functions in Smart mode
Function 7-segment
display
ACT
LED 1
SPD
LED 2
FD
LED 3
Exit Smart mode without changes 51 Off Off On
Activate the recovery procedure 55 On Off On
Activate the flash procedure 56 On On Off
Apply customized default profile 57 On On On
Table 8-7 Restored network setting
Network Mode Management IP #1 (IP address for internal interface)
Router https://192.168.1.1/
To Next Page
Loading...
