Phoenix Contact ILC 131 STARTER KIT - Page 33

Step-by-step development of an example project
105724_en_01 PHOENIX CONTACT 33
If you are using the addresses of a local network in your project, also assign the
corresponding address (e.g., 192.168.0.2) to the PC on which PC WORX EXPRESS is
installed. Otherwise the devices in the local network cannot be accessed.
For information on the IP addresses to be used within your system, please contact your
system administrator.
If the start address of the new address area to be entered is higher than the previous end
address, modify the end address first.
If you manually assign IP parameters that are outside the defined area, they will not be
accepted.
Example IP addresses are shown in the following screenshots. Adapt the IP address to
your system.