Phoenix Contact ILC 131 STARTER KIT - Appendixes; A 1 List of figures

105724_en_01 PHOENIX CONTACT 87
A Appendixes
A 1 List of figures
Section 2
Figure 2-1: ILC 131 STARTERKIT: installed components on the board ................11
Figure 2-2: ILC 131 STARTERKIT: example wiring for the inputs and the
supply lines .........................................................................................12
Figure 2-3: ILC 131 STARTERKIT: example of the Ethernet cabling ....................13
Section 4
Figure 4-1: User interface .....................................................................................17
Figure 4-2: IEC Programming workspace .............................................................19
Figure 4-3: Bus Configuration workspace .............................................................20
Figure 4-4: Process Data workspace ....................................................................20
Figure 4-5: “Edit Device Representation...” menu item ..........................................23
Figure 4-6: Device representations .......................................................................24
Figure 4-7: Examples of different device representations .....................................24
Figure 4-8: Project Control Dialog .........................................................................25
Figure 4-9: “Download Options” dialog box ...........................................................26
Figure 4-10: Project Control Dialog .........................................................................28
Section 5
Figure 5-1: Project creation sequence ..................................................................30
Figure 5-2: “New Project” dialog box: project templates ........................................31
Figure 5-3: “Save/Zip project as” window ..............................................................31
Figure 5-4: Project information after creating a new project ..................................32
Figure 5-5: Select “PROFINET Configuration ...” ..................................................35
Figure 5-6: “PROFINET” window ..........................................................................35
Figure 5-7: Bus configuration: Selecting the controller ..........................................36
Figure 5-8: DCP: Setting the IP address ...............................................................36
Figure 5-9: Starting IP address assignment via DCP ............................................37
Figure 5-10: Entering the MAC address ..................................................................39
Figure 5-11: “Extras, BootP/SNMP/TFTP-Configuration...” menu ...........................39
Figure 5-12: “Activate BootP” button .......................................................................39