58 PhoneSuite
®
Console User’s Manual rev. 081106
Command Speech Function
x*0 Listen to Secondary Message, where x is as above
x*4 Erase Secondary Message, where x is as above
*
*
Before a message can be re-recorded, it must be erased. If this message was the last one recorded, then it can
be erased using the command indicated and can then be re-recorded. However, if another message has been re-
corded since this message, then this command will not work; instead, you must erase and re-record ALL the
messages.
Messages are recorded and reviewed through the console handset. Commands are entered as indicated in
the above table; when a record command is used, you will hear a beep through the console handset, indicat-
ing the beginning of the recording. When you hear the beep, talk into the console handset to record your
message; when done, press D on the console.
Note: How the Auto Attendant handles calls (what ring it answers on and how it transfers them) is config-
ured by the installer.
To Next Page
Loading...