Physio Control LIFEPAK 9 - Page 208

Table
3
Delivered
Energy
Tolerances
Energy
Setting
Tolerance
Energy
Setting
Tolerance
1J
+0.2J
101
1.0]
2
+0.2J
201
2.0]
3]
30.3]
301
32.1]
4]
30.4)
50]
+3.5J
SJ
+0.5J
100J
+7.0J
6J
0.6]
200]
314.01
TJ
+0.7J
300J
+21.0J
8J
+0.8J
360]
25.2]
9]
30.9]
PIP-CODE
SUMMARY
1.
Press
ON
twice
to
switch
instrument
power
off
then
on.
Re
por Note: /fthe instrument has the automatic CODE SUMMARY
printing feature (805460-20), it will print out all the CODE
SUMMARY events in memory before it allows you to switch
the power off.
2. Secure the defibrillation cable to the energy meter electrodes.
3. Connect the ECG simulator to the patient cable and set for a
60 bpm-NSR signal.
4. Press SYNC.
5. If necessary, press & ENERGY SELECT W to set the energy level to
2001.
6. Press CHARGE. When full charge is reached (as indicated by the
tone and displayed message 200J AVAILABLE), simultaneously press
both adapter discharge pushbuttons to transfer the energy into the
energy meter.
7. Press RECORD twice to switch the recorder on, then off quickly.
. Press CODE SUMMARY.
9. Confirm that the format and appearance of the recorded data is similar
to the data shown below in Figure 2.
00
All Rights Reserved © October 1994 Physio-Control Corporation