Physio Control LIFEPAK 9 - Testing; Introduction; Performance Inspection Procedure (PIP)

mL
Testing
Introduction This section describes how to test, calibrate, and troubleshoot the LIFEPAK 9
defibrillator/monitor. Topics cover:
© © The Performance Inspection Procedure (PIP)
© The Test and Calibration Procedure (TCP)
e Troubleshooting Aids.
Note: Prefixes are used to distinguish testing steps.
PIP— identifies Performance Inspection Procedure steps.
TCP— identifies Test and Calibration Procedure steps.
Performance This Performance Inspection Procedure (PIP) checks whether a LIFEPAK 9
In spection defibrillator/monitor is performing within specifications. The
Procedure (PIP) defibrillator/monitor case does not need to be opened to perform the PIP.
The PIP Checklist (page 3-18) may be photocopied and used to record the
PIP results. If the defibrillator/monitor fails any part of the PIP, refer to the
Test and Calibration Procedure (page 3-20) and the Troubleshooting Aids
(page 3-40) for help in locating any failed subassemblies.
PIP-Purpose This PIP checks whether the LIFEPAK 9 defibrillator/monitor is performing
within specifications. Perform the PIP regularly as a periodic maintenance
check and after any repair or calibration.
170008-000 A
O
August
1993
Physio-Control
All
Rights
Reserved
3-1