Physio Control LIFEPAK 9 - Page 64

PIP-Keypad Test
170008-000 A
© August 1993 Physio—Control
Testing 3
The Keypad Test is initiated from the Test Menu (as shown in
Figure 3-2) which should be displayed from the end of the previous
step. Press Y ECG SIZE A to scroll to KEYPAD, then press HR ALARM
to start the Keypad Test.
Press the front panel pushbuttons and then the rear panel pushbuttons in
the following order:
Front Panel:
LEAD SELECT
y ECG SIZE
ECGSIZE A
y ENERGY SELECT
ENERGY SELECTA
HR ALARM
CHARGE
CODE SUMMARY
RECORD
SYNC
Rear Panel:
Y QRS VOL
QRS VOL A
MODE
1mV CAL
SET
Press the APEX paddle CHARGE pushbutton.
Press the APEX paddle discharge pushbutton; confirm no beep sounds.
Press the STERNUM paddle discharge pushbutton; confirm no beep
sounds.
Simultaneously press both paddle discharge pushbuttons; confirm that a
beep sounds.
Confirm that the monitor displays KEYPAD: OK, then press LEAD
SELECT to return to the Test Menu. If the pushbuttons are not pressed
in the order listed above, or if there is a pushbutton failure, the monitor
displays KEYPAD: FAULT. In this case, press W ECG SIZE À to scroll
to KEYPAD, then press HR ALARM to restart the Keypad Test and repeat
Steps 2 through 7.
To exit the Keypad Test after completion, press W ECG SIZE A to scroll
to EXIT and press HR ALARM to resume normal operation.
All Rights Reserved 3-7