Physio Control LIFEPAK 9 - Page 67

LIFEPAK 9 defibrillator/monitor
PIP-Rate Alarms/ 1. Press HR ALARM. Confirm that the HR ALARM LED is on and 150/40
Alarm-Activated is displayed in reverse video.
Record
2. While 150/40 remains displayed in reverse video, press HR ALARM
twice and confirm that 120/60 and 160/90 display consecutively.
3. Press HR ALARM to display 150/40 in reverse video. Confirm that after
about 2 seconds 150/40 displays in normal video.
4. | Set the ECG simulator rate to greater than 150bpm. Confirm that the
alarm sounds, the 150 flashes, and the recorder runs for approximately
16 seconds.
5. Confirm that the heart rate printed on the printout is 151bpm or higher.
6. Press HR ALARM and confirm that the alarm stops.
7. Decrease the ECG simulator rate to 30bpm. Press HR ALARM. Confirm
that the alarm sounds, the 40 flashes, and the recorder runs for
approximately 16 seconds.
8. Press HR ALARM and confirm that the alarm stops.
PIP-Recorder 1. Set the ECG simulator to 60bpm. j
Annotation/
Real-Time Clock 2. Set the defibrillator/monitor to local time. (Press TIME/DATE MODE on
the rear panel to display the clock setting; press TIME/DATE SET to
increment to the desired value in the displayed field, then press
TIME/DATE MODE to advance to the next field.)
3. Press RECORD and confirm the recorder begins printing with the date
and time annotated.
4. Confirm that the time is accurate to within +1 minute.
5. Press RECORD to stop the recorder.
PIP-Test Load 1. Make sure the paddles are stored in the paddle storage area of the
defibrillator/monitor.
2. Press W ENERGY SELECT A as necessary to set the energy level to
2001.
3. Press CHARGE.
170008-000 A
3-10 All Rights Reserved © August 1993 Physio—Control