Physio Control LIFEPAK 9 - Page 83

LIFEPAK 9 defibrillator/monitor
3. Press Y ECG SIZE A to scroll to the DEFIB test.
4. Press HR ALARM to start the DEFIB test.
5. Press Y ENERGY SELECTA to scroll to LOW. Select 1J..
6. Press CHARGE.
7. After the defibrillator/monitor reaches full charge as indicated by the
tone, simultaneously press both paddle discharge pushbuttons to transfer
the energy into the energy meter.
8. Confirm that the CRT displays the message JOULES DELIVERED:
XXX, where XXX is the energy selected.
9. Read the value on the energy meter.
10. Press Y ECG SIZE & as necessary to change the JOULES
DELIVERED: XXX value to match the value on the energy meter.
11. Press HR ALARM to enter the adjusted value.
12. Press CHARGE. After charging is complete, simultaneously press both
paddle discharge pushbuttons to transfer the energy into the energy
meter. Confirm that the energy meter value equals the selected value as
indicated in Table 3-8.
Table 3-8 Defibrillator Calibration Measurement Ranges
Selected Acceptable Range Selected Acceptable Range
Value (J) “Value (J) % Tolerance Value (J) “Value (J) % Tolerance
1 0.8 to 1.2 +20% 20 19.0 to 21.0 +5%
2 1.8 to 2.2 +10% 30 28.5 to 31.5 +5%
3 2.7 to 3.3 +10% 50 47.5 to 52.5 +5%
4 3.8 to 4.2 +5% 100 95.0 to 105.0 +5%
5 4.8 to 5.2 +5% 200 190.0 to 210.0 +5%
6 5.7 to 6.3 +5% 300 285.0 to 315.0 +5%
7 6.7 to 7.3 +5% 360 342.0 to 378.0 +5%
8 7.6 to 8.4 +5%
9 8.6 to 9.4 +5%
10 9.5 to 10.5 +5%
13. Press HR ALARM to reinitiate the DEFIB test.
14. Repeat steps 5 through 13 for each energy level.
15. Return the paddles to the paddle storage area on the defibrillator.
x
170008-001 Orig
3-26 All Rights Reserved © August 1993 Physio—Control