PI MS249E - Page 221

8 GCS Commands
C-863.12 Mercury Controller MS249E Version: 1.2.1 215
553
PI_CNTR_CS_COMBINATION_INVALID
The combination must consist
of one work and one tool
coordinate system
554
PI_CNTR_CS_TYPE_DOES_NOT_EXIST
This coordinate system type
does not exist
555
PI_CNTR_UNKNOWN_ERROR
BasMac: unknown controller
error
556
PI_CNTR_CS_TYPE_NOT_ACTIVATED
No coordinate system of this
type is activated
557
PI_CNTR_CS_NAME_INVALID
Name of coordinate system is
invalid
558
PI_CNTR_CS_GENERAL_FILE_MISSING
File with stored CS systems is
missing or erroneous
559
PI_CNTR_CS_LEVELING_FILE_MISSING
File with leveling CS is missing
or erroneous
601
PI_CNTR_NOT_ENOUGH_MEMORY
not enough memory
602
PI_CNTR_HW_VOLTAGE_ERROR
hardware voltage error
603
PI_CNTR_HW_TEMPERATURE_ERROR
hardware temperature out of
range
604
PI_CNTR_POSITION_ERROR_TOO_HIGH
Position error of any axis in
the system is too high
606
PI_CNTR_INPUT_OUT_OF_RANGE
Maximum value of input
signal has been exceeded
607
PI_CNTR_NO_INTEGER
Value is not integer
608
PI_CNTR_FAST_ALIGNMENT_PROCESS_IS_
NOT_RUNNING
Fast alignment process
cannot be paused because it
is not running
609
PI_CNTR_FAST_ALIGNMENT_PROCESS_IS_
NOT_PAUSED
Fast alignment process
cannot be restarted/resumed
because it is not paused
650
PI_CNTR_UNABLE_TO_SET_PARAM_WITH
_SPA
Parameter could not be set
with SPA - SEP needed?
651
PI_CNTR_PHASE_FINDING_ERROR
Phase finding error
652
PI_CNTR_SENSOR_SETUP_ERROR
Sensor setup error
653
PI_CNTR_SENSOR_COMM_ERROR
Sensor communication error
654
PI_CNTR_MOTOR_AMPLIFIER_ERROR
Motor amplifier error
655
PI_CNTR_OVER_CURR_PROTEC_TRIGGERE
D_BY_I2T
Overcurrent protection
triggered by I2T-module