PI MS249E - Page 224

8 GCS Commands
218 Version: 1.2.1 MS249E C-863.12 Mercury Controller
1073
PI_CNTR_PROFILE_UNKNOWN_CLUSTER_I
DENTIFIER
Unknown cluster identifier
1090
PI_CNTR_TOO_MANY_TCP_CONNECTIONS
_OPEN
There are too many open
tcpip connections
2000
PI_CNTR_ALREADY_HAS_SERIAL_NUMBER
Controller already has a serial
number
4000
PI_CNTR_SECTOR_ERASE_FAILED
Sector erase failed
4001
PI_CNTR_FLASH_PROGRAM_FAILED
Flash program failed
4002
PI_CNTR_FLASH_READ_FAILED
Flash read failed
4003
PI_CNTR_HW_MATCHCODE_ERROR
HW match code
missing/invalid
4004
PI_CNTR_FW_MATCHCODE_ERROR
FW match code
missing/invalid
4005
PI_CNTR_HW_VERSION_ERROR
HW version missing/invalid
4006
PI_CNTR_FW_VERSION_ERROR
FW version missing/invalid
4007
PI_CNTR_FW_UPDATE_ERROR
FW update failed
4008
PI_CNTR_FW_CRC_PAR_ERROR
FW Parameter CRC wrong
4009
PI_CNTR_FW_CRC_FW_ERROR
FW CRC wrong
5000
PI_CNTR_INVALID_PCC_SCAN_DATA
PicoCompensation scan data
is not valid
5001
PI_CNTR_PCC_SCAN_RUNNING
PicoCompensation is running,
some actions can not be
executed during
scanning/recording
5002
PI_CNTR_INVALID_PCC_AXIS
Specified axis cannot be
defined as PPC axis
5003
PI_CNTR_PCC_SCAN_OUT_OF_RANGE
Defined scan area is larger
than the travel range
5004
PI_CNTR_PCC_TYPE_NOT_EXISTING
Specified PicoCompensation
type is not defined
5005
PI_CNTR_PCC_PAM_ERROR
PicoCompensation parameter
error
5006
PI_CNTR_PCC_TABLE_ARRAY_TOO_LARGE
PicoCompensation table is
larger than maximum table
length
5100
PI_CNTR_NEXLINE_ERROR
Common error in NEXLINE®
firmware module
5101
PI_CNTR_CHANNEL_ALREADY_USED
Output channel for NEXLINE®
can not be redefined for
other usage