PI MS249E - Page 225

8 GCS Commands
C-863.12 Mercury Controller MS249E Version: 1.2.1 219
5102
PI_CNTR_NEXLINE_TABLE_TOO_SMALL
Memory for NEXLINE® signals
is too small
5103
PI_CNTR_RNP_WITH_SERVO_ON
RNP can not be executed if
axis is in closed loop
5104
PI_CNTR_RNP_NEEDED
Relax procedure (RNP)
needed
5200
PI_CNTR_AXIS_NOT_CONFIGURED
Axis must be configured for
this action
5300
PI_CNTR_FREQU_ANALYSIS_FAILED
Frequency analysis failed
5301
PI_CNTR_FREQU_ANALYSIS_RUNNING
Another frequency analysis is
running
6000
PI_CNTR_SENSOR_ABS_INVALID_VALUE
Invalid preset value of
absolute sensor
6001
PI_CNTR_SENSOR_ABS_WRITE_ERROR
Error while writing to sensor
6002
PI_CNTR_SENSOR_ABS_READ_ERROR
Error while reading from
sensor
6003
PI_CNTR_SENSOR_ABS_CRC_ERROR
Checksum error of absolute
sensor
6004
PI_CNTR_SENSOR_ABS_ERROR
General error of absolute
sensor
6005
PI_CNTR_SENSOR_ABS_OVERFLOW
Overflow of absolute sensor
position
Interface errors
0
COM_NO_ERROR
No error occurred during
function call
-1
COM_ERROR
Error during com operation
(could not be specified)
-2
SEND_ERROR
Error while sending data
-3
REC_ERROR
Error while receiving data
-4
NOT_CONNECTED_ERROR
Not connected (no port with
specified ID open)
-5
COM_BUFFER_OVERFLOW
Buffer overflow
-6
CONNECTION_FAILED
Error while opening port
-7
COM_TIMEOUT
Timeout error
-8
COM_MULTILINE_RESPONSE
There are more lines waiting
in buffer
-9
COM_INVALID_ID
There is no interface or DLL
handle with the specified ID