PI MS249E - Page 226

8 GCS Commands
220 Version: 1.2.1 MS249E C-863.12 Mercury Controller
-10
COM_NOTIFY_EVENT_ERROR
Event/message for
notification could not be
opened
-11
COM_NOT_IMPLEMENTED
Function not supported by
this interface type
-12
COM_ECHO_ERROR
Error while sending "echoed"
data
-13
COM_GPIB_EDVR
IEEE488: System error
-14
COM_GPIB_ECIC
IEEE488: Function requires
GPIB board to be CIC
-15
COM_GPIB_ENOL
IEEE488: Write function
detected no listeners
-16
COM_GPIB_EADR
IEEE488: Interface board not
addressed correctly
-17
COM_GPIB_EARG
IEEE488: Invalid argument to
function call
-18
COM_GPIB_ESAC
IEEE488: Function requires
GPIB board to be SAC
-19
COM_GPIB_EABO
IEEE488: I/O operation
aborted
-20
COM_GPIB_ENEB
IEEE488: Interface board not
found
-21
COM_GPIB_EDMA
IEEE488: Error performing
DMA
-22
COM_GPIB_EOIP
IEEE488: I/O operation
started before previous
operation completed
-23
COM_GPIB_ECAP
IEEE488: No capability for
intended operation
-24
COM_GPIB_EFSO
IEEE488: File system
operation error
-25
COM_GPIB_EBUS
IEEE488: Command error
during device call
-26
COM_GPIB_ESTB
IEEE488: Serial poll-status
byte lost
-27
COM_GPIB_ESRQ
IEEE488: SRQ remains
asserted
-28
COM_GPIB_ETAB
IEEE488: Return buffer full
-29
COM_GPIB_ELCK
IEEE488: Address or board
locked
-30
COM_RS_INVALID_DATA_BITS
RS-232: 5 data bits with 2
stop bits is an invalid
combination, as is 6, 7, or 8