PI MS249E - Page 228

8 GCS Commands
222 Version: 1.2.1 MS249E C-863.12 Mercury Controller
valid)
-57
COM_SOCKET_TERMINATED
Connection terminated (by
peer)
-58
COM_SOCKET_NO_RESPONSE
Can't connect to peer
-59
COM_SOCKET_INTERRUPTED
Operation was interrupted by
a nonblocked signal
-60
COM_PCI_INVALID_ID
No device with this ID is
present
-61
COM_PCI_ACCESS_DENIED
Driver could not be opened
(on Vista: run as
administrator!)
-62
COM_SOCKET_HOST_NOT_FOUND
Host not found
-63
COM_DEVICE_CONNECTED
Device already connected
DLL errors
-1001
PI_UNKNOWN_AXIS_IDENTIFIER
Unknown axis identifier
-1002
PI_NR_NAV_OUT_OF_RANGE
Number for NAV out of range-
-must be in [1.10000]
-1003
PI_INVALID_SGA
Invalid value for SGA--must be
one of 1, 10, 100, 1000
-1004
PI_UNEXPECTED_RESPONSE
Controller sent unexpected
response
-1005
PI_NO_MANUAL_PAD
No manual control pad
installed, calls to SMA and
related commands are not
allowed
-1006
PI_INVALID_MANUAL_PAD_KNOB
Invalid number for manual
control pad knob
-1007
PI_INVALID_MANUAL_PAD_AXIS
Axis not currently controlled
by a manual control pad
-1008
PI_CONTROLLER_BUSY
Controller is busy with some
lengthy operation (e.g.,
reference move, fast scan
algorithm)
-1009
PI_THREAD_ERROR
Internal error--could not start
thread
-1010
PI_IN_MACRO_MODE
Controller is (already) in
macro mode--command not
valid in macro mode
-1011
PI_NOT_IN_MACRO_MODE
Controller not in macro
mode--command not valid
unless macro mode active