Refitting
Carry out the above operations by working in the
reverse order from those of the removal.
Locking torques (N*m)
Handlebar fixing screw (*) 43 ÷ 47
Removal
After removing the upper seat, lean the vehicle on
one side and extract the steering tube completely
from the fork.
Specific tooling
020055Y Wrench for steering tube ring nut
Overhaul
- Remove the lower screw (1);
- Drain oil from suspension;
- Slide off the stem;
- Replace the sealing rings (3-4) with new ones;
- Fit the new sealing rings only after lubricating their seats;
- Refit the stem and the lower screw (1);
- Unscrew the cap (2);
- Pour 133±2.5 cm³ of Selenia Fork 10W oil per stem on the KAYABA fork, recognisable by the mark
stamped on the sleeves inner side (wheel side)
- Pour 145 cm³ of Selenia Fork 10W oil per stem on the MVP fork, recognisable by the label with the
"S" on the sleeve external side near the wheel axle.
- Refit all parts following the removal steps but in reverse order.
Suspensions X9 Evolution 125
SUSP - 168
To Next Page
Loading...
