- Remove the flywheel cover together with the water pump from the engine (see chapter 4).
- Remove the rotor cover by unscrewing the 3 retainers indicated in the figure.
- Place the flywheel cover on the ring base forming part of the drw. No. 020440Y tool.
N.B.: To avoid damaging the cover surface that retains the coolant, use de ring base with the accurately
machined surface facing the flywheel cover.
With an appropriate socket and punch, forming part of the specific tool 020440y, extract the shaft to-
gether with the rotor from the drive and the bearings.
- Use a screwdriver to remove the static part of the ceramic seal from the flywheel cover.
- Place the flywheel cover below the socket making sure it is perfectly levelled.
- Use the punch in the inverted position to extract the two ball bearings.
X9 Evolution 125 Cooling system
COOL SYS - 193
To Next Page
Loading...
