2
BIP-6000
Manual
FCC RF EXPOSURE INFORMATION
WARNING! Read this information before using your phone
In August 1996 the Federal Communications Commission (FCC) of the United States with its action in Report and Order FCC 96-326
adopted an updated safety standard for human exposure to radio frequency (RF) electromagnetic energy emitted by FCC regulated
transmitters.
Those guidelines are consistent with the safety standard previously set by both U.S. and international standards bodies. The design of
this phone complies with the FCC guidelines and these international standards.
CAUTION : Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or attachments could impair call
quality, damage the phone, or result in violation of FCC regulations. Do not use the phone with a damaged antenna. If a damaged
antenna comes into contact with the skin, a minor burn may result. Please contact your local dealer for replacement antenna.
Body-worn Operation
This device was tested for typical body-worn operations with the back of the phone kept 1.5 cm. from the body.
SAR compliance for body-worn operation is restricted to belt-chips, holsters or similar accessories that have no metalic component in the
assembly.
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.
BIP-6000 Device(FCC ID : SS4P1770) has also been tested against this SAR limit. The highest SAR value reported under this standard
during product certification for use at the ear0.424W/kg and when properly worn on the body is 0.289 W/kg.
WARNING
Any changes or modification not expressly approved by the party responsible could void the user's authority to operate the device.
Knowing the product
To Next Page
Loading...
