INDEX
© 2020 Pierce Manufacturing Inc. All Rights Reserved. / Index-3
External Transmission Coolers
................... 6-28
F
Fan and Accessory Belts ........................... 6-20
Fan Clutch ............................................. 5-40
Fasteners ................................................. 6-7
Fault Light Information ................................ 6-6
Finish Touch-Up and Repair ....................... B-7
Fire Scene Operation ............................... 5-17
Fire Service Ratings ................................. 6-41
Fluid Level (Non-Maintenance-Free Batteries) 6-17
Fluid Requirements .................................. 5-42
Flying Embers ......................................... 5-17
Foot Pedals, Adjustable ............................ 4-12
Fording Water with Command Zone™
Vehicles
...................................... 5-19
Frame Fasteners ....................................... 6-8
Front Axle – Non-Driving ............................. 6-9
Front Axle – TAK-4™ Suspension ................. 6-9
Front Axle Alignment .................................. 6-9
Front Axle Drive, To Disengage .................. 5-46
Front Axle Drive, To Engage ...................... 5-46
Front Spring/Suspension Adjustment ........... 3-11
Front Tires ............................................. 6-45
Frontal Impact Protection .......................... 4-10
Fuel Delivery System ................................ 6-25
Fuel Filters ............................................. 6-25
Fuel System ........................................... 6-25
Fuses and Circuit Breakers ........................ 5-15
G
General Fording Instructions ...................... 5-18
General Inspection ................................... 6-29
General Inspection and Service .................. 6-22
General Warnings and Cautions ................... 2-2
Goldstar Striping Repair Instructions ............. B-7
Grade Holding and Brake Burnishing ........... 5-56
Graphics, Lettering, and Striping .................. B-1
H
HAAS Alert ............................................. 4-22
Hand Throttle .......................................... 5-44
Hazard Flashers ...................................... 5-16
Heater Shut-Off ........................................ 6-2
Heating, Ventilation, Air
Conditioning (HVAC)
....................... 6-2
High Heat Sources ................................... 5-17
High Idle ................................................ 5-36
High Pressure Hydraulic Fluid ...................... 2-9
Hinges .................................................... 6-2
Hose and Hose Reels ............................... 4-16
Hose Clamps .......................................... 6-22
Hoses .................................................... 6-22
Hourmeter .............................................. 5-15
Hub Piloted Wheel Installation .................... 6-47
HVAC - Velocity™/Impel™/Saber® 2014/
Enforcer™
.......................... 4-13, 4-14
HVAC- Velocity™/Impel™ ......................... 4-13
HVAC)- Velocity™/Impel™
Air Conditioning
......................... 4-13, 4-14
Defroster .................................. 4-13, 4-14
Heater ..................................... 4-13, 4-14
Hydraulic Retarder ................................... 5-58
I
Idling the Engine ...................................... 5-35
Ignition and Starter Switches ...................... 5-16
Inflatable Head Curtain (IHC) ....................... 4-8
Initial Inspection Upon Deliver ...................... 7-1
Input/Output Sheets (I/O Sheets) ................. 6-16
Inspection, Approaching the Vehicle ............. 5-1
Inspection, Brake Drums or Shoes ................ 5-2
Inspection, Equipment Loading .................... 5-3
Inspection, Exhaust System ........................ 5-3
Inspection, Pre-Trip ................................... 5-1
Inspection, Records Review ........................ 5-1
Inspection, Steering System ........................ 5-2
Inspection, Suspension System ................... 5-3
Inspection, Tires ....................................... 5-2
Inspection, Wheels and Rims ...................... 5-2
Inspections, Scheduled .............................. 7-1
Instrument Panel ...................................... 4-16
Instrument Panel Controls & Indicators ......... 4-16
Integrated Belt Pretensioner (IBP) ................ 4-8
Integrated Gas Pretensioner (IGP) ................ 4-8
Inter Axle Differential (IAD)
Lock (Tandem Axles)
..................... 5-50
Interior Fasteners ...................................... 6-7
Interior Inspection ..................................... 5-4
To Next Page
Loading...
