Pilz PITreader - 3 Safety; 3.1 Intended use; 3.2 Safety regulations; 3.2.1 Additional documents that apply

Safety
Operating Manual PITreader, PITreader Firmware V1.5.x
1004806-EN-08
| 10
3 Safety
3.1 Intended use
The PITreader is a system for authentication and authorisation on control systems. Authen-
tication is via transponder key.
The following is deemed improper use in particular
} Any component, technical or electrical modification to the product,
} Use of the product outside the areas described in this operating manual,
} Use of the product outside the technical details (see Technical details [ 51]).
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
3.2 Safety regulations
3.2.1 Additional documents that apply
You should also read and take note of the following documents:
} Operating manual of the PITreader you are using
(e.g. PITgbRLLEyupETH, PITgbRLLEydownETH)
} Operating manual PITreader REST API
} Operating manual PITreader OPC Server UA
3.2.2 Use of qualified personnel
The products may only be assembled, installed, programmed, commissioned, operated,
maintained and decommissioned by persons who are competent to do so.
A competent person is a qualified and knowledgeable person who, because of their train-
ing, experience and current professional activity, has the specialist knowledge required. To
be able to inspect, assess and operate devices, systems and machines, the person has to
be informed of the state of the art and the applicable national, European and international
laws, directives and standards.
It is the company’s responsibility only to employ personnel who
} Are familiar with the basic regulations concerning health and safety / accident prevention,
} Have read and understood the information provided in the section entitled Safety
} Have a good knowledge of the generic and specialist standards applicable to the specific
application.