Pilz PITreader - 7 Wiring; 7.1 Standalone; 7.2 Base unit with safe evaluation unit

Wiring
Operating Manual PITreader, PITreader Firmware V1.5.x
1004806-EN-08
| 34
7 Wiring
7.1 Standalone
Follow the instructions below:
1. Connecting the supply voltage
a Connect the supply voltage to X1 (Pin "24V" and "0V").
It is essential to note:
The power supply must meet the regulations for extra low voltages with protective
electrical separation (SELV, PELV).
The cables for the device's supply voltage must be fitted with a 4A fuse, character-
istic B/C.
2. Connect the PITreader to a controller (PLC, HMI) via the Ethernet interface (X2).
7.2 Base unit with safe evaluation unit
Follow the instructions below:
1. Connect the PITreader to a safe evaluation unit PIT m4SEU (see also PIT m4SEU op-
erating manual).